Check out our wide variety of name badges in various sizes, shapes and finishes, to create a professional look for any business. Unless noted, all badges have a radius corner edge. Magnetic backings and pins are sold separately.Heat transfer vinyl (HTV) and adhesive vinyl can also be applied to these sublimation blanks.

Download free sublimation template

Specification

• SIZE: 1.25" x 3"(31.8mm x 76.2mm)
• SUBSTRATE:FiberReinforced Plastic (FRP)
• THICKNESS:0.09" / 2.29mm
• COATING:White
• FINISH:Gloss

Volume Pricing

• Pack of 50 $0.82 /Blank
  
• Pack of 100 $0.79 / Blank
• Pack of200 $0.74 / Blank

Materials needed -

• Unisub Fiber-reinforced Plastic (FRP)Blank
• Sublimation Printer
• Heat Press
• Heat Tape
• Cleaning Cloth
• Blowout Paper (teflon sheet not recommended)
• Printed Transfer
• Printing RIP Software
• Heat Gloves
• All-Purpose Cleaning Fluid
  

Directions -

1. Clean the name badge using microfiber cloth, all-purpose cleaner, and/or compressed air.
2. With bare sides facing up, press name badges at 385F/195C following th times for each surface in the chart. Time may vary based on equipment. Increase time if pressing more than one badge at a time.
   
3. Remove the transfer, let cool, and attach magnetic backing or pin (not included)Attention:the item will be hot, so wear protective heat gloves for removal.

*The stated sublimation times are only valid for prints made on small desktop sublimation printers.

INSTRUCTIONS